Overview: This course is intended as an introduction to finite element analysis, using the integrated mode of Pro/MECHANICA. The course will cover all the modules of Pro/MECHANICA with an emphasis on structure. You will learn to calculate stresses, natural frequencies, and deformation of parts, and to perform optimization studies. The end result will be reduced design time and reduced cost by providing concurrent simulation during the design process.

Discussion:
Discuss the difference between ANSYS Cosmos and Mechanica
Discuss strengths and weaknesses of Mechanica
Discuss reduced design time by providing concurrent simulation during the design process
Discuss how to set up a model for solving beams
Discuss solving for sheetmetal products such as battery contacts or brackets.
Discuss solving for assemblies
Discuss solving for weldments
Discuss Louvers for sheetmetal
Discuss the fringe plot of Von Mises stress anaylisis and the FEA solutions for optimizing a solution for strength cost.
We develop all of our own training material in HTML for students to access during and after the classes.

Pro/MECHANICA and ANSYS workshops
Mechanica I Mechanica II Mechanica III ANSYS I ANSYS II

Sitemap

Pro/MECHANICA and ANSYS workshops

> Mechanica I
> Mechanica II
> Mechanica III
> ANSYS I
> ANSYS II